9 Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.
Figure 9.1 Cut the seal cap strap across the rectangles next to the disk. For rear vent, skip this step.
Figure 9.2 Remove the white gasket material covering the seal cap.
Figure 9.3 Remove the seal cap.
Figure 9.4 Remove the insulation basket and white insu- lation from the center vent pipe.
Figure 9.5 Remove the insulation from the outer vent pipe. For rear venting there is no insulation in the outer vent pipe.
Figure 9.6 To attach the first section of vent pipe, make sure to use the fiberglass gasket in the manual bag to seal between the first vent component and the outer fireplace wrap. Use 2 self tapping screws to secure the gasket to the outer wrap.
Secure the first section of venting to the fireplace by screw- ing through the two straps left over from cutting the seal cap strap in step 2.
Heat & Glo • | 35 |
