Heat & Glo LifeStyle 8000CMOD-IPI Appliance Setup, A. Remove Fixed Glass Assembly, D. Accessories

14 Appliance Setup

A. Remove Fixed Glass Assembly

See Section 14.G.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Glass Panel Installation

CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation.

CAUTION! Glass is fragile. Handle with care.

1.Install the rear glass panel as shown in Figure 14.1. the panel retainers and screws are included in the ap- pliance manual bag.

Note: Screw the three glass panel retainers to the fire- box using the EXISTING pilot holes.

2.Slide the side glass panels in positions as shown in Figure 14.2.

3.Figure 14.3. shows the glass panels installed properly.

REAR RETAINER

Figure 14.1 Install Rear Retainer

Figure 14.2 Install Side Glass Panels

SIDE RETAINERS

Figure 14.3 Install Side Retainers

52 Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12