B. Installing Vent Components
Venting Out the Top Vent
The glass must be taken off again for positioning the logs when the unit is finally installed in place and finished around it.
1.Attach the First Vent Component to the Starting Collars
To attach the first vent component to the starting collars of the fireplace:
•Make sure that the fiberglass rope ring supplied in the manual bag seals between the first 8 inch (203mm) vent component and the outer fireplace wrap (see Figure 14).
OUTER | FIRST VENT COMPONENT |
WRAP | |
| FIBERGLASS ROPE |
| RING |
Figure 14. Fiberglass Rope Ring | |
Refer to Cinch Pipe (DVP) and Termination Cap installation instructions.
!WARNING: ENSURE THAT THE FIBERGLASS GASKET SUPPLIED WITH THE FIREPLACE
SEALS BETWEEN THE FIRST VENT COMPONENT AND THE OUTER FIREPLACE WRAP.
2. Continue Adding Vent Components
•Continue adding vent components
•Ensure that each succeeding vent component is secure- ly fitted and locked into the preceding component in the vent system. Securing pipe sections with a maximum of two screws is recommended.
•90° elbows may be installed and rotated to any point around the preceding component’s vertical axis. If an el- bow does not end up in a locked position with the pre- ceding component, attach with a minimum of two (2) sheet metal screws.
3. Install Support Brackets
Refer to Cinch Pipe and Termination Cap installation instructions.
Heat & Glo • GEM42 • | 17 |
