E. Rock Media Instructions
CAUTION
Sharp Edges
•Wear protective gloves and safety glasses during installation.
Cleaning the Rock
During shipment of the Rock Media, dust and debris can accumulate. It is recommended that the Rock Media be rinsed thoroughly with water to remove dust and small glass particles. An easy method to clean the Rock Media is to dump the rocks into a bucket and rinse thoroughly with a garden hose. Allow the rocks to dry before installing them into the fireplace.
INSTALLATION
1.Choose 7 - 10 flat,
NOYES
Figure 14.1. Selecting Flat Rocks for Pilot Cover.
Î
WARNING
Delayed Ignition Risk
•Place stones according to instructions.
•Do NOT place stones in area in front of pilot or between burner tracks.
•Do NOT place stones in a position that they may fall into area in front of pilot.
•Do NOT use any media other than the stones supplied with this fireplace.
•Do NOT use more than one 10 lb. bag of rock media per fireplace.
Fireplace will not function properly.
Delayed ignition may occur.
2.Place an even layer of decorative rock around the base pan as shown in Figure 14.2. Do not place rocks in the slot over the burner ports. See Figures 14.2 and 14.3. This may cause lighting issues, undesirable burner flame, or delayed ignition.
BURNER PORT SLOT MUST BE FREE OF ROCKS
Figure 14.2. Place Rock Media | Î |
WARNING! Risk of Fire. DO NOT place rock media di- rectly in front of the pilot assembly or between the burner tracks over the burner ports..
3.Figure 14.4 shows an outline of the area in front of the pilot assembly. No rock media may be placed in the
outlined area. Continue to place an even amount of Rock Media over the entire base pan. DO NOT install Rock Media in between the tracks over the entire length of the burner.
DO NOT PLACE ROCK MEDIA
BETWEEN BURNER TRACKS
Figure 14.3. Burner Tracks
DO NOT PLACE ROCK MEDIA
IN FRONT OF PILOT ASSEMBLY
Figure 14.4. Pilot Bracket Detail | Î |
Heat & Glo • SLR • | 55 |
