F. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Fixed Glass Assembly
1.Remove the decorative front.
2.Locate the two spring latches that are on the upper left and right of the fireplace.
3.Use both index fingers to release spring latches. See Figure 14.3.
4.Allow glass to tilt forward. Grasp glass on the upper right and left sides and lift glass “up” and “out.”
Replacing Fixed Glass Assembly
1.Locate glide tabs on lower left and right corners.
2.Grasp glass on upper right and left sides and tilt bot- tom of glass assembly toward fireplace.
3.Allow of the bottom gasketing of the glass assembly to touch the face of the fireplace.
4.Put pressure on the glass as you allow the glass assembly to drop into the two lower glass clips. See Figure 14.3.
5.Tilt top of glass towards fireplace and engage both top spring latches
UPPER SPRING LATCH
LOWER GLASS CLIP
G. Install the Mesh
The mesh front is included with the Tonic front. The Mar- tini tinted glass front does not include mesh.
1.Remove fixed glass assembly as instructed.
2.Place glass assembly into mesh screen such that the four mesh clips attached to the mesh assembly snap into the four corresponding slots on the fixed glass as- sembly.
H. Air Shutter Setting
Air shutter settings may be adjusted by a qualified install- er at the time of installation. The air shutter is set at the factory for minimum vertical vent run. Adjust air shutter for longer vertical runs. See Figure 14.4.
•Loosen the 1/4 in. screw.
•Twist shutter to adjust
•Shutter may be open for longer horizontal vent runs.
•Do not close the air shutter more than 1/16 in. for NG or 5/16 in. for LP.
•Tighten the screw.
NOTICE: If sooting occurs, provide more air by opening the air shutter.
Figure 14.4 Air Shutter
Air Shutter Settings
| NG | LP |
SLR | 1/16 in. | 5/16 in. |
Figure 14.3 Fixed Glass Assembly
Heat & Glo • SLR • | 57 |
