XTP T UWP 202 Wallplate Transmitter • Installation and Operation 4
Installation and Operation
This section contains information for mounting, connecting, and wiring the XTP T UWP 202.
Topics in this section include:
• Installation Overview
• Installing the Metal Junction Box or Mud Ring
• Rear and Side Panel Connectors
• Mounting the XTP T UWP 202
• Front Panel Connectors
• Making Connections
• Operation

Installation Overview

The XTP T UWP 202 can be installed into the provided mud ring or an UL Listed metal
electrical junction box.
ATTENTION: If using a junction box, use a metal one only.
1. Prepare the mounting surface.
CAUTION: Risk of personal injury. Failure to check the items listed below may
result in personal injury.
ATTENTION: Failure to check the items listed below may result in property
damage.
• Ensure there are no utility cables or pipes at the intended location that might be
damaged or cause injury when installing the device.
• Check that the installation meets building, electrical, and safety codes.
• Ensure there is sufficient space behind the device.
• Choose a location that will allow cable runs without interference.
NOTES:
• Cables may need to be installed in the wall or conduits before installation.
• The mud ring does not require attachment to wall studs.
• For metal junction boxes, refer to the manufacturer for more installation
requirements.
2. Cut a hole in the mounting surface (see Cutting an Opening in the Mounting
Surface on page 5).
3. Install the mud ring or metal junction box in the mounting surface (see Installing the
Mud Ring on page 6 or Installing a UL Listed Metal Junction Box on page 7).