XTP T UWP 202 Wallplate Transmitter • Installation and Operation 10
Front Panel Connectors
PWR HDCP HDMI
HDMI IN
LAN
VGA
RESET
CONFIG
AUDIO
CLIP
AUTO
SWITCH
AUDIO IN
VGA IN
A
DBCE
A HDMI input connector
B Analog audio input connector
C Analog video input connector
D LAN connector (LAN models only)
E Configuration port
Figure 8. Front Panel Connectors (LAN Model Shown without the Decora
Faceplate)
A HDMI input connector — Connect a digital video source device to the HDMI
connector. It can accept HDMI, DVI (with an appropriate adaptor), or dual mode
DisplayPort video sources.
NOTES:
• The maximum HDMI cable length is 15 feet.
• Use an Extron LockIt lacing bracket to secure the HDMI connector to the
device (see HDMI Connection on page 11).
B Analog audio input connector — Connect an analog audio source to the 3.5 mm
tip-ring-sleeve (TRS) jack.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring (
-
)
Tip (+)
Audio Plugs.eps
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Sleeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo Plug Connector
(unbalanced)
Figure 9. Wiring a TRS Connector for Audio
By default, audio input is selected automatically (see Audio input selection SIS
commands on page 20 to manually select audio inputs). When the HDMI input is
selected with automatic audio input selections, the transmitter prioritizes embedded
digital audio. The table on page 11 shows the audio format that is sent over the XTP
connection when a specific audio format is not specified.