Extron electronic XTP T UWP 202 A, B, C, D

XTP T UWP 202 Wallplate Transmitter • Installation and Operation 8

A XTP output connector — Connect a twisted pair cable to the RJ-45 connector

labeled XTP Out on the XTP T UWP 202 and the XTP input port on another XTP device

to pass all signals (see TP Cable Termination and Recommendations on page 12).

This cable carries the following signals:

• Digital video

• Digital audio

• Bidirectional RS-232 and IR commands

• Remote power

• Ethernet communication

• System communication

Signal LED indicator — Lights green when the transmitter outputs an

XTP signal to a compatible receiver or matrix switcher.

Link LED indicator — Lights yellow when XTP devices are connected

and communication is established.

ATTENTION:

• Do not connect this connector to a computer data or telecommunications

network.

• XTP remote power is intended for indoor use only. No part of the network that

uses XTP remote power should be routed outdoors (see Remote power on

page 15).

B RS-232 Over XTP port — To pass bidirectional serial or other control

signals between XTP-compatible devices, connect a control device to the

5-pole direct insertion captive screw connector. The port includes only the 3

poles labeled “RS-232.”

IR Over XTP port — To transmit and receive IR signals (up to 40 kHz),

connect a control device to the 5-pole direct insertion captive screw

connector. This port includes only the 2 poles labeled “IR” and shares the

ground pole with the RS-232 port.

NOTE: RS-232 and IR data can be transmitted simultaneously (see

RS-232 and IR Over XTP Communication on page 13 for wiring details).

C Remote RS-232 connector — Connect a host device to the 3.5 mm, 3-pole direct

insertion captive screw connector for serial control of the transmitter.

D Power connector and LED — Connect an external power supply to the 2-pole direct

insertion captive screw connector. Confirm the polarity of the power supply wires. The

Power LED lights to indicate the device is receiving power.

NOTE: The XTP T UWP 202 can also be powered remotely (see Power

Connection on page 14).

Tx Rx G

Tx Rx

RS-232

Tx Rx G

Tx Rx

RS-232

Signa

Link