Extron electronic XTP T UWP 202 2, , , 3

XTP T UWP 202 Wallplate Transmitter • XTP System Configuration Software 32
General tab
Click the General tab (see figure 30, 1) to open the General screen. It contains settings for
auto switch mode and factory reset.
Figure 30. General Tab
Auto-input Switching panel
2 Auto-input Switching — Click the Enable Auto-Input Switching check box to
enable auto switch mode. Two settings are available for this mode:
Õ Click the Priority to highest active input number radio button to
automatically switch to the highest numbered active input (HDMI).
Ö Click the Priority to lowest active input number radio button to
automatically switch to the lowest numbered active input (VGA).
Factory reset
3 Factory Reset — Click the Factory Reset button to reset the transmitter to factory
settings except for firmware.
NOTE: This is the same as the EZXXX SIS command (see the System reset
command on page 22).