XTP T UWP 202 Wallplate Transmitter • Installation and Operation 6
Installing the Mud Ring
Backing Clip
Mounting Sc
rew
Rotate the backing clip
out of the way to insert
the mud ring into the wall.
Figure 2. Installing the Mud Ring with Backing Clips
1. Place 1.25 inches (3.18 cm) long or 0.75 inch (1.90 cm) #6-32 thread machine screws
through the large holes in the two corners of the mounting bracket. Use the shortest
possible screw needed.
2. Loosely fasten the mounting backing clip on the end of each screw.
3. Insert the mounting bracket into the opening in the wall.
4. Rotate each backing clip so that the tab is behind the installation surface to hold the
bracket snuggly in place when the screw is tightened.
Detail A
0.75" #6-32 Scr
ew
Backing Clip Backing Clip
Mountint Surface Mounting Surface
Detail B
1.25" #6-32 Screw
Figure 3. Backing Clip Installation
NOTE: The backing clip can be installed as shown in detail A or detail B (see
figure 3).
5. Use a cross-head (Phillips) screwdriver to fasten the screws and backing clips in place.