XTP T UWP 202 Wallplate Transmitter • SIS Configuration and Control 22
Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
EDID Commands
NOTE: For EDID management, use the XTP System Configuration Software (see EDID Minder on page 34).
Advanced Configuration Commands
HDCP authorized device (HDMI input only)
HDCP authorized device On EE1HDCP}HdcpE1]Designate the transmitter as
an HDCP authorized device
(default).
HDCP authorized device Off EE0HDCP}HdcpE0]Do not designate the
transmitter as an HDCP
authorized device.
Query HDCP authorized
device status
EEHDCP}HdcpEX$] View the HDCP authorized
device status.
Test pattern
Set a test pattern X1)J TstX1) ] Set a test pattern or disable
one.
View the current test pattern JTstX1)] View the current test pattern
setting.
Factory defaults
System reset EZXXX}Zpx]Resets unit to factory default.
Status
View input signal presence 0LS FrqX1!X1! ] View the input signal presence
of each input. In the response,
the first X1! is the VGA input.
The second X1! is the HDMI
input.
Query HDCP input status EIHDCP}HdcpI0X1@] View the HDCP status of the
HDMI input.
Query firmware version Qx.xx]View the firmware version.
Query full firmware version *Q x.xx.xxxx]View the full firmware version.
Query part number N60-1216-12] or
60-1410-12]
View the device part number.
The response is based on
the model. Black and white
models are not differentiated.
NOTE: X$ = HDCP authorization 0 = HDCP authorization off
1 = HDCP authorization on (default)
X1) = Color bars test pattern 0 = disable (default)
1 = 720p @ 50 Hz
3 = 720p @ 60 Hz
5 = 1080p @ 60 Hz
X1! = Video signal status 0 = video or TMDS not detected
1 = video or TMDS detected
X1@ = HDCP status 0 = no source connected
1 = HDCP compliant source
2 = non-HDCP compliant source