XTP T UWP 202 Wallplate Transmitter • Installation and Operation 16
OperationAfter all transmitters, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly. If problems persist, call the Extron S3 Sales & Technical Support
Hotline. See the contact numbers on the last page of this guide for the nearest Extron
office.
Indicators
PWR HDCP HDMI
HDMI IN
LAN
VGA
RESET
CONFIG
AUDIO
CLIP
AUTO
SWITCH
AUDIO IN
VGA IN
A
BC
Figure 15. Front Panel Indicators (LAN Model Shown without the Decora
Faceplate)
A Signal LED Indicators:
Power LED indicator — Lights when power is applied to the unit.
HDCP LED indicator — Lights when the input signal is encrypted.
HDMI LED indicator — Lights when an HDMI input video signal is detected.
VGA LED indicator — Lights when a video signal is detected on the VGA input.
B Audio clipping LED indicator — Lights when the analog audio input signal is -3 dBFS
or above. The light remains lit for 200 ms after the audio input signal drops below
-3 dBFS.
C Auto switch LED indicator — Lights when the transmitter is in auto switch mode.
EDID
To manage EDID on the XTP T UWP 202, use the XTP System Configuration Software
(see EDID Minder on page 34). The XTP T UWP 202 can record and save EDID in a user
memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the transmitter is assigned by the matrix
switcher using the XTP System Configuration Software.