XTP T UWP 202 Wallplate Transmitter • Installation and Operation 11
Selected
Video Input
HDMI Embedded
Audio Present
Analog Audio
Present
Audio Sent Over XTP
VGA N/A Yes Analog audio
VGA N/A No No audio
HDMI Yes No HDMI embedded audio
HDMI Yes Yes HDMI embedded audio
HDMI No Ye s Analog audio
HDMI No No No audio
C Analog video input connector — Connect a video source to the female 15-pin HD
connector. It accepts RGBHV video signals.
D LAN connector (LAN model only) — Connect a control device or device to be
controlled to this LAN connector for 10/100 Ethernet communication through this
pass-through port. LEDs on this connector indicate link and activity status.
E Configuration port — If desired, connect a host device to the front panel USB mini-B
Config port for configuring the transmitter.
Making Connections

HDMI Connection

Use an Extron LockIt Lacing Bracket to secure an HDMI cable to each connector. The
following instructions describe how to attach one HDMI LockIt Lacing Bracket. For more
stability, attach a second HDMI LockIt Lacing Bracket to the other mounting screw.
HDMI IN
1
2
3
Figure 10. Attaching the HDMI Connector and HDMI LockIt Lacing Bracket
1. Plug the HDMI cable into the panel connection (see figure 10, 1).
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it (see figure 10, 2). The screw does not have
to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket (see figure 10, 3).
ATTENTION: Do not overtighten the HDMI connector mounting screw. The shield
it fastens to is very thin and can easily be stripped.
4. Loosely place the included tie wrap around the HDMI
connector and the LockIt lacing bracket as shown (see
the image to the right).
5. While holding the connector securely against the lacing
bracket, use pliers or similar tools to tighten the tie wrap, then
remove any excess length.
HDMI IN