Heat & Glo LifeStyle VRT-BZ-N-AUB, VRT-GY-N-AUB Electrical Information, A. Wiring Requirements

12 Electrical Information

A. Wiring Requirements

NOTICE: This appliance must be installed by a qualified electrician in accordance with the relevant national and local regulations.

•Wire the appliance junction box to 220-240 VAC. This is required for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire 220-240 VAC to the valve or to the appliance wall switch. Incorrect wiring will damage controls.

NOTICE: The mains supply to the appliance must have isolation of a minimum 3 mm contact separation in both poles.

WARNING! Risk of Injury! The gas supply shall be shut off prior to disconnecting the electrical power and remov- ing batteries (if installed) before proceeding with any maintenance to the appliance.

B. IntelliFire PlusTM Ignition System Wiring

•Wire the appliance junction box to 220-240 VAC for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire IPI controlled appliance junction box to a switched circuit. Incorrect wiring will override IPI safety lockout.

•Refer to Figure 12.1, IPI Wiring Diagram.

•This appliance is equipped with an IntelliFire PlusTM control valve which operates on a 6 volt/1.5 AMP system.

•Plug the 6 volt transformer plug into the appliance junction box to supply power to the appliance OR install 4 AA cell batteries (not included) into the battery pack before use.

•An in-line isolation switch must be installed within 1 meter of the fireplace. This is required for servicing and/ or resetting the control module in the event of a control module LOCK-OUT.

C. Optional Accessories Requirements

•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.

Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.

•Hearth & Home Technologies recommends that Intel- liFire PlusTM wireless controls be used for their features and functionality with the IntelliFire PlusTM ignition sys- tem.

WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105 ºC rated wire. Wire must have high temperature insulation.

					240V FAN
GROUND
TO CHASSIS		IGNITOR
TO AUX300CE
		FLAME
		SENSE
DC REGULATOR 6V DC SUPPLY
	CONTROL MODULE
		I		AUX300CE MODULE
		S WHITE	NGERAO
					FAN
					AUX 1 AUX 2	TO JUNCTION
						BOX 230 VAC
		8K1 WIRE			TO OPTIONAL
		HARNESS
					COMPONENTS
		RED			OPTIONAL ON/OFF
ORANGE	GREEN
		BLACK			WALL SWITCH
(PILOT)	(MAIN)
		BROWN			BATTERY PACK
					6V DC (C X 4)
Figure 12.1 IPI Wiring Diagram /RC300AU		GROUND
Heat & Glo • VRT-AUB • 2123-980 Rev. H • 5/12						55