32

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

This appliance must be installed in accordance with local codes, if any; if not, follow ANSI Z223.1 or, in Canada, current CAN/CGA-B149.

Standing Pilot

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn knob. Never use tools. If the manual gas valve will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

This appliance must be properly connected to a venting system in accordance with the manufacturer's installation instructions.

WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner's information manual provided with the appliance. For assistance or additional information consult a

Ignition

LIGHTING INSTRUCTIONS

Stop! Read the safety information above on this label.

qualified installer, service agency or the gas supplier.

CAUTION: Hot while in operation. Do

Heatilator • Novus BV-Mesh • 4031-553 Rev F • 11/07

1.Turn wall switch to the "OFF" position or thermostat to the lowest setting.

2.Remove control access panel.

3.Turn manual gas valve to CLOSED. Wait five [5] minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to next step.

4.Turn gas line to "OPEN".

5.Turn pilot knob clockwise to "OFF". (Knob may have to be depressed to pass "PILOT" position.)

6.Locate pilot assembly inside appliance.

7.Locate red ignitor button.

8.Turn pilot knob to "PILOT" and push in.

9.Continue to hold in pilot knob and push the red ignitor button 12-15 times until small blue pilot flame appears.

10.Continue to hold in pilot knob for approximately one minute. Pilot should remain lit. If pilot goes out, wait 5 minutes and repeat

Steps 3-9.

 

11. Release and turn knob counterclockwise

to "ON".

12.If appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your service technician or gas supplier.

3. CLOSED

7

4. OPEN

5

OFF

VENT

ON

 

8 11

not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.

WARNING RISK OF FIRE

This appliance is intended to burn a specified gas fuel only. Do not attempt to use with solid wood fuel or another type of fuel. Do not attempt to modify or use any other type of gas burner system.

WARNING: Disconnect the electric power before servicing. If for any reason the original wire supplied with the appliance must be replaced, it must be replaced with 105° C or its equivalent.

For use with natural gas or propane. A conversion kit as supplied by the manufacturer shall be used to convert this appliance to the alternative fuel.

NOTE: To light main burner, turn wall switch to "ON". Do not light by hand.

PILOT5

ON OFF

ON

OFF

PILOT

OFF ON

PIL OT

* Also certified for installation in a bedroom or a

bed-sitting room.

TO TURN OFF GAS TO APPLIANCE

1.

Turn off wall switch or set thermostat to lowest setting.

3.

Turn manual gas valve to "CLOSED position. Do not force.

2.

Remove control access panel.

4.

Replace control access panel.

Due to high surface termperatures, keep children, clothing and furniture away.

 

Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.

29097D

 

* For U.S. only!

NATURAL GAS

Page 31 Page 33
Page 32
Image 32
Heatiator NB4236MI, NB4842MI, NB3933MI, NB3630MI owner manual For Your Safety Read Before Lighting, Ignition
Page 31 Page 33

NB3933M, NB3630M, NB3630MI, NB3933MI, NB4236M specifications

The Heatiator series of gas fireplaces, including the models NB4236MI, NB4842MI, NB3933M, NB4236M, and NB3933MI, epitomizes modern heating technology with a focus on efficiency, design, and user comfort. These models are engineered to provide warmth while enhancing the aesthetic appeal of any living space.

One of the standout features of the Heatiator series is its advanced combustion technology. The fireplaces are designed to maximize heat output while minimizing emissions. This is achieved through high-quality burners that ensure a clean and efficient flame, allowing users to enjoy the ambient glow without compromise. The models boast impressive thermal efficiencies, meaning they convert a high percentage of the fuel consumed into usable heat, which is an essential factor for eco-conscious consumers.

Design flexibility is another key characteristic of the Heatiator fireplaces. The models in this series come in various sizes and styles, offering options that can blend seamlessly into any decor. Whether you prefer a traditional look or a more contemporary aesthetic, there’s a model to suit your taste. The large viewing areas provided by the glass front panels offer an unobstructed view of the flame, adding a cozy ambiance to your home.

The Heatiator NB4236MI and NB4842MI models feature innovative multi-function remote controls, giving users the convenience of adjusting settings from anywhere in the room. This built-in technology not only enhances user experience but also contributes to energy savings by allowing precise control over the fireplace's operation.

Safety is also a priority with the Heatiator lineup. Equipped with features such as an automatic shut-off system and tempered glass fronts, users can enjoy peace of mind knowing that safety is paramount.

In terms of customization, these models offer various finishes and log options, allowing homeowners to personalize their fireplaces to match their style and preferences.

Overall, the Heatiator NB4236MI, NB4842MI, NB3933M, NB4236M, and NB3933MI represent a perfect blend of technology, safety, and design sophistication, making them an excellent choice for anyone looking to add a reliable and attractive heating solution to their home. Whether for supplemental heat or a primary heating source, these fireplaces are built to deliver exceptional performance in any setting.
Top Page Image Contents