Hitachi 42HDW10 user manual Installation and Cabling, Connecting to a PC

ENGLISH

INSTALLATION INSTRUCTIONS (continued)

Installation and Cabling

Connecting to a PC

■ Read SAFETY GUIDELINES ( I to VII ) carefully to ensure maximum safety before proceeding to these steps:

1)Make sure that the display signals produced by your PC meet the specifications of this product.

•For the specifications of this product, see Product Specifications ( 27 to 29 ).

2)Choose an appropriate site and install the product on a level table where the stand is secure.

•Install the monitor to have ready access to a power socket available.

3)Make sure that your PC’s power switch is off.

4)Interconnect the signal input terminal (RGB1) on the monitor rear panel and the display signal output terminal of the PC to each other using the signal cable included.

•Optional cables are needed to connect to the RGB2 input and audio input terminals.

•If the signal cable included does not match your PC, consult your dealer after reading the section “Signal Input”. 28

5)Insert one end of the power cable included into the rear-panel power cable connector and the other end into a power socket.

6)Turn on the monitor, then the PC to make sure that a display image appears on the monitor screen.

•For instructions on turning on the monitor and adjusting its display images, see “Operating Instructions” ( 9 to 19 ).

Speaker (R)	Monitor rear panel
		Speaker (L)

Power cable connector

AUDIO IN

Power	RGB 1
	D-SUB IN RGB 2
cable

V H B G R

To signal input terminals

To signal

output terminal

To signal input terminals

To signal

output terminal

To audio input terminals

3.5mm Stereo mini jack

To audio output terminal

Cord Clamper

When connecting a computer audio input to the unit (using a 3.5mm stereo mini jack), the cord must pass through the cord clamp toward the bottom of the back of

PC

the main unit. If it does not, there is a possibility of insufficient suppression of electromagnetic radiation.

6