ENGLISH
21
■The on-screen display system shown to the right will be displayed when the
SELECT button is used to select DISPLAY
and moreover DISPLAY INIT is selected from
the On-screen Display System . If the
key (select YES) of the SELECT button is
pressed at this time, the user adjustment values
in the table below for the signal currently being
received will be deleted and the factory settings
will be restored.
• Pressing the key (select NO) cancels deletion and returns the DISPLAY MENU.
Reset (Settings Initialization)
12
DISPLAY menu item Display Application
Horizontal position H.POSITION RGB1, RGB2
Vertical position V.POSITION RGB1, RGB2, VIDEO1, VIDEO2
Dot clock frequency CLOCK RGB1, RGB2
Dot clock phase PHASE RGB1, RGB2
Vertical size V. SIZE VIDEO1, VIDEO2
■Changes in the signal status are displayed on the screen as they arise.
RGB1 [D-SUB]
H : 46.5kHz, V : 60.0Hz
POWER SAVE
OUT OF FREQUENCY
Either VIDEO or S VIDEO is
displayed on VIDEO input.
Signal Check
Status Display Action
The input signal was
switched or the
RECALL button was
pressed after AUTO
FREQ was turned on.
• The input terminal and the
horizontal and vertical
frequencies are displayed in
a guidance image.

-

A sync signal could not
be detected.
• The guidance message
“POWER SAVE” is
displayed for about 5
seconds.
• In the event of continued
absence of a sync signal,
the power indicating lamp
flickers and the monitor
enters power save mode.
• Check the power switch of
the PC and its status of
connection.
The input signal does
not meet display
specifications or erratic.
• The guidance message
“OUT OF FREQUENCY” is
displayed.
• Check the input signal
specifications once again.
30
27
VIDEO1
VIDEO
RGB
~