Hitachi 55DMX01WD specifications Connecting a Stereo VCR or Stereo Laserdisc Player

CONNECTING EXTERNAL VIDEO SOURCES

CONNECTING A STEREO VCR OR STEREO LASERDISC PLAYER

1.Connect the cable from the VIDEO OUT of the VCR or the laserdisc player to the INPUT (VIDEO) jack, as shown on the TV set below.

2.Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack.

3.Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack.

4.Press the VID1~VID3 button to view the program from the VCR or laserdisc player. The VIDEO icon disappears automatically after approximately eight seconds.

5.Press the ANT button to return to the previous channel.

Rear Panel of Television

			L							ANT A
				5	4		3	2	1
				10		9	8	7	6
				15	14		13	12	11
			R
S-VIDEO	S-VIDEO	S-VIDEO	PC AUDIO							TO
				PC RGB INPUT 1
			INPUT 1
										CONVERTER

SUB	+	-
WOOFER
		L
L
R	R
	+	-
AUDIO
TO HI-FI	REAR SPEAKER 8Ω ONLY

		VIDEO	Y	VIDEO	Y	VIDEO
	STOP	(MONO)	P B	(MONO)	P B	(MONO)	ANT B
		L		L		L
	CONNECT ONLY 8 OHM SPEAKERS
	DO NOT SHORT CIRCUIT		P R		P R
	THESE TERMINALS
	(Such damage is NOT COVERED	R		R		R
	by your television warranty)
		AUDIO		AUDIO		AUDIO
COAXIAL	OPTICAL					MONITOR
INPUT	INPUT	INPUT 1		INPUT 2
						OUT

Back of

VCR

R L V

OUTPUT

VCR

Hitachi Model or

Similar Model

NOTES: 1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is played back will be abnormal if the connection is loose.

2.A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output. (INPUT: 1 in example on page 13) Refer to your VCR operating guide for more information on line input-output connections.

19