OPERATIONS
STANDBY/ON Button
POWER Indicator
STANDBY/
ON Button
Zoom knob
Focus ring
Power Switch | Slide Lens door |
|
STANDBY/ON | VIDEO RGB |
KEYSTONE
MENU
SELECT
MENU POSITION RESET
MAGNIFY | FREEZE VOLUME |
|
|
Power ON
1.Check that the power cord is connected correctly.
2.Set the power switch to [ ]. The standby mode is selected, and the POWER indicator is turned to orange.
3.Press the STANDBY/ON button 
on the control panel or the remote controller.
4.The POWER indicator ceases blinking and turns to green when power is on. Open the slide lens door.
5.Adjust picture size using the Zoom knob.
6.Adjust focus using the Focus ring.
Power OFF
1.Press the STANDBY/ON button 
on the control panel or the remote controller. Then, the message "Power off?" will appear on the screen,and the message will disappear by any operation or no operation for 5 seconds.During this messsage indication,press the STANDBY/ON 
button again. The projector lamp is extinguished and lamp cooling begins. The POWER indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button 
has no effect while the POWER indicator is blinking.
2.The system assumes the Standby mode when cooling is complete, and the POWER indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3.The POWER indicator is extinguished when power is off. Do not forget to close the lens door.
WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE • Except in emergencies, do not turn off unless the POWER indicator is orange as it will reduce the life of the projector lamp.
•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a
•When a projector continues projecting the same image, the image may remain as an afterimage. Please do not project the image same for a long time.
Downloaded from www.Manualslib.com manuals search engine
