Hitachi DV-PF2U instruction manual DVD/VCR to TV Connection, Switch, Setting the CH3/CH4

The following show examples of connections commonly used to connect the DVD/VCR to TV and other components.

Notes

¡Be sure to turn off the power to all components in the system before connecting another component.

¡Refer to the Instruction Manuals for your TV, stereo system and any other components to be connected to the DVD/VCR.

DVD/VCR TO TV CONNECTION	SETTING THE CH3/CH4
	SWITCH

English

1.Disconnect the AC power cord of the TV from the AC outlet.

2.Disconnect the antenna or cable from the TV.

3.Connect the antenna or cable to the ANT-IN jack of the DVD/VCR.

4.Connect the DVD/VCR to the TV using the coaxial cable.

5.Plug the AC power cords of the DVD/VCR and TV into the AC outlets.

[VHF/UHF	[Indoor antenna]	[Back of the DVD Player]
combination antenna]			[Back of the
			UHF/VHF combination TV]
	OR	ANT - IN	Coaxial cable
			(supplied)
[Cable	box or satellite box] OR		UHF/VHF
		ANT - OUT
			3CH 4CH
From Cable or
Satellite Company

If your TV does not have A/V terminals:

When the DVD/VCR is in the VCR Playback mode or when the DVD/VCR is in the VCR mode, your TV will receive signals from the DVD/VCR on either channel 3 or channel 4. To use the DVD/VCR with your TV, set the selector switch to CH3 or CH4 (which is located in the back of your DVD/VCR), whichever is not used for normal broadcasts in your area. Then set your TV to the same channel.

ANT - IN

CH3 CH4 - OUT

CH3 CH4

[Back of the DVD Player]

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that pro- vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building, as close to the point of cable entry as practical.

– 17 – EN

2C15