Hitachi DZMV550A, DZMV580A Using Remote Control, Viewing Subject Through Viewfinder

●Using Remote Control

Point the remote control to the infrared receiver on the DVD video camera/recorder. The remote controllable distance is up to 16 feet (5 m).

Infrared receiver

	10˚
15˚	10˚
	15˚
			)
			m
		5
	(
	t
	e
	fe
	6
	1
	.
	rox
	p
	p
	A

Note:

•When using the remote control, make sure that the infrared receiver on DVD video camera/recorder is not exposed to direct sunlight or any intense light. If the infrared receiver is subject to light stronger than the infrared light from remote control, the DVD video camera/recorder cannot be operated by remote control.

•If there is an obstacle between the remote control and infrared receiver on DVD video camera/recorder, remote control may not be possible.

•The DVD video camera/recorder uses the “VCR2” remote control code of Hitachi VCRs. If you use a Hitachi VCR, etc. with remote control code set to “VCR2”, a VCR placed near the DVD video camera/recorder will also be operated by the remote control: To prevent this, change the remote control code of the VCR.

VIEWING SUBJECT THROUGH VIEWFINDER

1 Pull out the viewfinder. Diopter control Viewfinder

2 Turn the diopter control knob to adjust the focus to suit your eyesight.

Note:

•If no image appears in viewfinder, refer to “Check 6” on page 164.

•If the LCD monitor is open approximately 90°, the viewfinder will be off.

•Focusing will not be correct unless the viewfinder is pulled out.

English

Pull out the finder until a click is heard.

34