English
ACCESSORY BOX
Check all contents.
HANDLE COMP (RIGHT) | STAND – 2pcs |
| |
HANDLE COMP (LEFT) | SHAFT COMP |
| |
HANDLE STAY – 2pcs | WHEEL – 2pcs |
| |
HOOK COMP | WASHER – 2pcs |
| |
HOOK STAY – 2pcs |
| ||
LONG BOLT | SHORT BOLT |
| |
LONG BOLT | HOOK COMP |
| |
HOOK STAY |
| ||
LONG BOLT | LONG BOLT | LONG BOLT | |
HANDLE COMP | HOOK STAY | ||
HANDLE COMP | |||
|
| NUT | |
HANDLE STAY | SHORT BOLT | HANDLE STAY | |
|
| ||
| WHEEL |
| |
SHORT BOLT |
|
| |
STAND |
|
| |
Fig.4 | SHAFT COMP |
| |
WASHER |
|
ASSEMBLING THE WHEEL KIT
Tools Required ; 12mm wrench
1.Install the two WHEELS on the SHAFT COMP using the WASHERS and
2.Install the WHEEL assembly on the generator using the four M8 x L14mm
3.Install the two STANDS on the under frame using the six M8 x L14mm
ASSEMBLING HANDLE KIT
Tools Required ; 12mm wrench
1.Install the HANDLE COMP (RIGHT and LEFT) on the generator upper frame using the HANDLE STAY and the four M8 x L18mm
ASSEMBLING HOOK COMP KIT
Tools Required ; 12mm wrench
1.Position the HOOK COMP at the generator’s balance point as shown Fig.5
2.Fit the end tabs of the HOOK STAY through the HOOK COMP slots, and bolt the HOOK STAY to the HOOK COMP using the four M8 x L18mm
HOOK COMP | 10.7 | 13.0 in | |
(270 | 330 mm) | ||
|
HANDLE
Fig.5
APPLICATIONS
Power source of electric appliances and tools.
WARNING: HITACHI electronic controlled products should not be used with portable generators. Irregular generator power could cause these products to fail.
Regarding other manufacturer's products, please contact the manufacturer to see if it is safe to use the electronic controlled products with portable generators.
PREPARATION BEFORE OPERATION
Before starting the generator, check the oil and fuel levels. Test the GFCI outlets as directed on page5 of this manual. Be sure that the air cleaner is functioning. Follow the guidelines below when adding oil and fuel.
8
