Additional Information
Troubleshooting
If you experience any of the following difficulties while using the system, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest ser- vice center.
No power.
•Is the power cord firmly plugged into the power outlet?
•One of the safety mechanisms may be operating. In this event, unplug the player from the power outlet briefly and then plug it in again.
No picture.
•Check that the system is connected securely.
•The video connecting cord is damaged. Replace it with a new one.
•Make sure you connect the system to video input connector on the TV (see page 17).
•Make sure you turn on the TV.
•Make sure you select the video input on the TV so that you can view the pictures from this system.
The picture noise appears.
•Clear the disc.
•If video from this system has to go through your VCR to get to your TV, the
The aspect ratio of the screen cannot be changed even though you set “TV DISPLAY” in the SETUP menu when you play a wide picture.
•The aspect rate is fixed on your DVD disc.
•If you connect the system with the
•Depending on the TV, you may not change the aspect rate.
There is no sound or only a very low-level sound is heard.
•Check that the speakers and components are connected securely.
•Make sure that you have selected the correct source on the system.
•Press MUTE button on the remote control if the red LED on the front panel is blinking.
•The protective device on the system has been activated because of a short circuit. Turn off the system, eliminate the
•The audio connecting cord is damaged. Replace it with a new one.
•The system is in pause mode or in
or fast forward or fast reverse is performed. Press 
to return to normal play mode.
•Check the speaker settings (see page 15~17, 31~32).
