Convection Oven
Light open top burner pilots before lighting oven pilot.
1.Open kick panel (see Fig. 12) and lift up the pilot lighting hole cover.
2.Turn red gas valve ON (located behind the kick panel), purging the gas line of all air (Fig. 14). Turn gas valve and power switch OFF. Close oven door. Wait 5 minutes.
Fig. 14 | Fig. 15 |
3.Light oven pilot by depressing the reset button (Fig. 15) and using a taper to light the pilot. Hold reset button in for 30 seconds or until pilot remains lit. Turn gas valve ON.
4.If pilot fails to light, turn main gas supply OFF. Wait 5 minutes and repeat Steps 2 and 3.
5.After pilot is lit, push the power switch ON and turn the thermostat to the desired setting.
Nightly Shutdown: Turn the power switch OFF and the thermostat to 0 degrees.
Complete Shutdown
1.Turn thermostat to 0 degrees.
2.Push power switch OFF.
3.Turn red gas valve OFF (behind kick panel).
4.Turn main gas supply OFF.
5.Disconnect electrical supply cord.
Convection Oven With Spark Ignition (Fig. 16)
1.Move rocker switch to ON position.
2.Once oven pilot is established, the oven READY light will illuminate.
3.Set oven thermostat to desired temperature. Thermostat light will illuminate. This indicates that the thermostat is calling for heat.
The convection oven thermostat must be on and calling for heat for oven pilot to light.
Nightly Shutdown: Push rocker switch and turn all knobs to the OFF position.
Complete Shutdown
1.Push rocker switch and turn all knobs to the OFF position.
2.Turn main gas supply OFF.
–14 –
