Hobart Welding Products 625 manual Installation, Specifications For Torch

.A complete Parts List is available at www.HobartWelders.com

SECTION 4 − INSTALLATION

4-1. Specifications

	Amperes Input at							Rated	Maximum
	Rated Load				Rated	Type of	Plasma
50/60 Hz	Output 50/60 Hz				Output	Output	Gas	Cutting	Open-Circuit
								Capacity	Voltage DC
	208 V	230 V	KVA	KW
					40 A @ 140	Direct	Air Or	0.5 in
Single-						Current,
					Volts DC,
	33	30	6.8	6.7		Straight	Nitrogen	(12.7 mm)	260
Phase					50% Duty
						Polarity	Only	At 16 IPM
					Cycle
						(DCEN)

4-2. Specifications For Torch

Air-cooled torch for plasma arc cutting (PAC)

50% duty cycle

Safety interlock devices disable power source

Safety trigger guard

Cutting capacity: see Section 4-1

4-3. Duty Cycle And Overheating

For Units Connected to a 208 Volt Circuit or a 230 Volt Circuit:

50% Duty Cycle At 40 amperes, 140 volts dc (typical cutting)

5 Minutes Cutting 5 Minutes Resting

Overheating

Duty Cycle is percentage of 10 minutes that unit can cut at rated load without overheating.

If unit overheats, output stops,

temperature status light illuminates, and cooling fan runs. Wait fifteen minutes for unit to cool or temperature light to go off. Reduce amperage or duty cycle before cutting or gouging.

YExceeding duty cycle can damage unit and void warranty.

A

0
	15
Minutes	OR
	Reduce Duty Cycle	sduty1 5/95 / Ref. 803 219

4-4. Torch Dimensions And Weight

8-3/8 in

(213 mm)

1 in (25 mm)

3.5 lb (1.6 kg) With 25 ft (7.6 m) Cable

1-3/8 in (35 mm)

Ref. 801 397-A

OM-926 Page 10