Hobart Welding Products OM-198 683C manual Installing Work Clamp, Installing Welding Gun

2-5. Installing Work Clamp

5

1

2

3

4

1Work Cable

2Boot

Slide boot onto work cable. Route cable out front panel opening from inside.

3 Negative (–) Output Terminal

Connect cable to terminal and cover connection with boot.

4Hardware

5Work Clamp

Route cable through clamp handle and secure as shown.

Close door.

Tools Needed: 1/2, 3/4 in

802 474-A

2-6. Installing Welding Gun

1

3

1Drive Assembly

2Gun Securing Knob

3Gun End

Loosen securing knob. Insert gun end through opening until it bottoms against drive assembly (make sure gun end does not touch drive rolls). Tighten knob.

4 Gun Trigger Plug

Insert plug into receptacle, and tighten threaded collar.

Close door.

4

2

Ref. 802 064-A

2-7. Connecting Olympic 30A Gun

The Olympic 30A welding gun connects directly to the 10-pin receptacle on the front of the welding power source – no adapter required. NOTE: Two welding guns may be connected to the welding power source at the same time, but only one welding gun may be in use at any one time. If the triggers of both welding guns are pulled at the same time, the weld output and wirefeed motor are disabled.

OM-198 683 Page 11