SETUP
Configuration and Advanced Control Programming (ACP)
The Setup menu is used to configure operating parameters, program your system to do its automated control and security functions using ACP, and give text and voice descriptions to all of your zones, units, buttons, codes, temperatures, and messages. To enter the Setup menu, from the
Upon entry to the Setup mode, you will first be prompted to enter a security code:
SET UP
ENTER CODE:
A Master Code is required to enter the Setup mode.
SET UP |
| 3=PROG ↓ |
1=CODES 2=TIME | ||
4=DIAL | 5=ARM | 6=MISC |
7=NAMES | 8=VOICE | ↑ |
Set Up Codes
Omni IIe has 16 user codes that you may assign to users of the system. All Omni IIe security codes are 4 digits in length (0001 to 9999). Each user should be assigned a security code with an authority level, areas that can be accessed (if area arming is being used), and times in which the code will be valid. To set up a code, from the Setup menu, press the 1 (CODES) key. Use the arrow keys to scroll through the codes.
User Code 1 is always set to a Master code. The existing code number is not shown on the display. To change the code, enter a four digit number, then press the ' # ' key.
Remember the code number. It will not be redisplayed.
CODE 2:
Authority Level
Press the (↓) key. You will then be prompted for an authority level for that code:
|
| CODE 2 AUTHORITY: | 3 | |
|
| 1=MSTR 2=MGR 3=USER |
| |
|
|
|
| |
| AUTHORITY | DESCRIPTION |
| |
|
|
| ||
1 | = Master | Master codes have complete access to the entire system. | ||
|
| |||
|
|
| ||
2 | = Manager | Manager codes can arm and disarm areas that they have access to, during assigned times. Managers can | ||
access the Main Menu if the system is in High Security Mode, and have telephone access privilege. | ||||
|
| |||
3 | = User | User codes can only arm and disarm the system in assigned areas, during assigned times. Telephone access | ||
is not a privilege. |
| |||
|
|
| ||
Access Areas |
|
| ||
After an authority level has been entered, you will be prompted for access areas for the user. Specify which area(s) (if part of your system) the user has access to by pressing the number for each area.
The display will show all areas that have been enabled for that user. After the area(s) is/are selected, press the ' # ' key.
CODE 2 AREAS: |
|
1 2 | 0=CLR |
Page 52
