Installing the CD Changer
26.Carefully unpack the CD changer. Remove the three shipping clips, and discard the shipping cover. Save the shipping clips for your customer in the event the unit needs to be serviced.
SHIPPING CLIP
SHIPPING COVER (Discard.)
ADHESIVE SEAL
27.Install an adhesive seal (included with the CD changer kit) over each of the three clip holes.
LEFT LOCKING COVER (supplied with CD Changer kit)
RIGHT LOCKING
COVER
(supplied with
FOR VERTICALCD Changer kit)
INSTALLATION
SPRING ADJUSTING PIN
VERTICAL POSITION
28.Visually check the location of the spring adjusting pins on both sides of the CD changer. If the spring adjusting pins are not in the vertical
(V)position, move the pins to the vertical (V) position with a small
29.Remove the backing from the two adhesive covers, and attach one cover to each side of the CD changer. Align the two diagonally opposite holes with the H and V positions.
30.Position the front and rear brackets on the CD changer, and install four 4 x 8 mm washer- screws into each bracket.
FRONT
BRACKET
CD CHANGER
REAR
BRACKET
4 x 8 mm
WASHER- SCREW
4 x 8 mm
31.Using a utility knife, cut out the inside line of the center area on the CD changer trim.
CD CHANGER
TRIM
OUTSIDE LINE
Do not cut here.
Cut out.
INSIDE LINE
Cut here.
© 2001 American Honda Motor Co., Inc - All Rights Reserved. | AII 23268 (0110) | 7 of 10 |
