Changing Image Scanner Name - via Bar codes

If you wanted to set up your image scanners with names 0001-0007, you may scan the bar codes below. Scan the Reset bar code after each name change and wait for the image scanner to re-link to the base before scanning the next bar code to name the next image scanner.

0001

0002

0003

0004

0005

0006

0007

Reset

Alternatively, you may change the name with a bar code command if you cannot send serial commands to the base. One way to do this is to scan the bar code below and scan a number for the image scanner name. For example, if you had 7 image scanners to one base, scan the bar code below with the first image scanner, scan the 1 bar code on the Programming Chart inside the back cover of this manual and scan Save. Then scan the Reset bar code and wait for the image scanner to re-link to the base before scanning the next bar code. Repeat that process for image scanner number 2, 3, 4 etc.

Image Scanner Name

If you want to assign an alphabetic name to the image scanner, create a Code 128 bar code containing “~BT_NAMname.” followed by a FNC3 character (hexi- decimal 83), where name is the new image scanner name. Scan the Reset bar code (page 1-8or on the Programming Chart inside the back cover of this man- ual). You may use Barcode Builder, which is included with Quick*View. You

may download Quick*View from the Honeywell International Inc. website: at www.honeywellaidc.com.

1 - 8