2.Disconnect the keyboard cable from the back of the terminal/computer.

3.Connect the

appropriate interface cable to the base and to the terminal/ computer and keyboard. Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal surface.

4.Turn the terminal/computer power back on.

5.Program the base for the keyboard wedge interface. See "Keyboard Wedge Connection" on page 1-21.)

6.Verify the base operation by scanning a bar code from the Sample Symbols in the back of this manual.

Note: Without using the 9-volt external, power supply, the base only uses enough power from the host to operate the interface. The image scanner’s battery is not charged when in this mode. Using the 9-volt, external power supply allows the image scanner’s battery to be charged, and no power is drawn from the host.

1 - 19