Cable Installation (Interface Specific)

RS232

9.Turn on the host system.10.Scan the Recall Defaults bar code.

Note: The Recall Defaults bar code is located in the MetroSelect Configuration Guide, under Need to Start Over (PN 00-02407x).

11. Configure the scanner to match the host system’s RS232 parameters.

Note: Refer to the MetroSelect Configuration Guide (PN 00-02407x) under Section G: RS232 for enabling RS232 Mode (scan the recall defaults bar code first).

Refer to the MS2x20 Stratos Series Scanner/Diva Scale Configuration Addendum (PN 00-02272x) for scale, dual cable and single cable configuration bar codes.

xx** Specifies international connection. See the Base Kit Components and Optional Accessories section of this guide for a complete listing.

See power source caution statement on page 13 of this manual.

Figure 19. RS232 Interface Cable Installation Schematic

23