MOTOR
PULLEY
AGITATOR
PULLEY
PR‘OJECTIONSiOT
Return nozzle to original position and lift up back of nozzle cover. Then remove cover, rotating it forward and lifting it off.
To remove the agitator, position your hand underneath the nozzle base at the agitator opening and push up the belt end of the agita- tor. Remove agitator and old belt.
Place one end of new belt around the plastic agitator pulley, with lettering on outside of belt.
Then slip other end of belt around motor pulley.
Position round projection on end of agitator (opposite the belt) into the opening in the wall of the nozzle base.
Slide belt end of agitator into place by pulling agitator forward and lining up metal projection on end of agitator with slot in wall of nozzle base. Then push agitator down into position.
Roll agitator to make sure belt is
Ipositioned properly.
16
