Hoover S3239, S3237 manual How to replace agitator brushes and brush roll

ION

How to replace agitator brushes and brush roll

Disconnect cleaner from electri- cal outlet and disconnect elec- tronic power nozzle from exten- sion wands.

Remove nozzle cover, agitator and belt following directions in “How to replace belt” section.

1. Hold agitator as shown. Turn end plates in opposite directions until one end plate comes off.

2.Pull or pry out end sections as shown in illustration.

Note: Remove brush roll and then pulley end section by pulling straight out.

3.Note position of bar-brush as- semblies to assure correct re- placement.

Remove bar-brush assemblies by pulling them from agitator slots. Use pliers if necessary.

The word “BAR” is stamped near the slots on the agitator.

Match the bar side of the bar- brush assembly with the label on the agitator shell. Slide the new assemblies into the slots, while twisting the assemblies in a coun- terclockwise motion. Push in as far as possible, tapping the other end lightly if necessary. Be sure brushes and bars are aligned for full length of agitator.

18