Hoover S3237, S3239 manual The headlight, How to replace the headlight

4.Line up locator on end sections with slot on agitator. Push end sections into position.

Note: The pulley end section has a U-shaped locator that fits into the U-shaped slot on the appro- priate agitator end.

5.Slide new brush roll onto pulley end section, fitting in- dented areas on brush roll over projections on end section. Ar- row in brush roll must point to- ward agitator.

6.Screw on end plates and tighten.

7.Should you accidentally dis-

place any part of the agitator dur- ing assembly, reassemble as shown.

			SHAFT ,goer through cen,er of ag,tatorl	METAL
	PLASTIC		I	BEARING
END	DUST	WASHER BRUSH	u--	COVER
PLATE	SHIELD

I

SPACER

’I

FL*7	METAL	END PULLEY
SIDED	BEARING	SECTION
PROJECTION	COVER	PROJECTION

Replace belt, agitator and nozzle cover.

The headlight

The headlight located on top of the electronic power nozzle operates when the cleaner is turned on.

Note: The headlight bulb is part of the electronic circuit and the elec- tronic power nozzle motor will not operate if the bulb is burned out. The bulb must be replaced with a 15 watt bulb. Use Hoover part number 16113 or Sylvania 15l7DC bulb.

How to replace the headlight

Disconnect cleaner from electrical outlet and disconnect electronic power nozzle from extension wands.

19