HotBrick Network Solutions

Note:

If there is an entry or entries in the Routing table with an Index of zero ( 0 ), these are System entries. You cannot modify or delete these entries.

Settings – Routing

Dynamic

RIP v2 – This acts as “master” switch. If enabled, the selected WAN or LAN

Routing

will run RIPv1/v2, otherwise they don’t have RIP function.

 

LAN, WAN1, WAN2 – If enabled, any WAN or LAN can execute RIP function.

 

 

Static

Network Address - The network address of the remote LAN segments. For

Routing

standard class "C" LANs, the network address is the first 3 fields of the

 

Destination IP Address. The 4th (last) field can be left at 0.

 

Netmask -The Network Mask for the remote LAN segments. For class "C"

 

networks, the default mask is 255.255.255.0

 

Gateway -The IP Address of the Gateway or Router which the VPN 800/2

 

Firewall Router must use to communicate with the destination above. (NOT the

 

router attached to the remote segment.)

 

Interface - Select the correct interface, usually "LAN". The "WAN" interface is

 

only available if NAT (Network Address Translation) is disabled.

 

Metric - The number of "hops" (routers) to pass through to reach the remote LAN

 

segment. The shortest path will be used.

Configuring Other Routers on your LAN

All traffic for devices not on the local LAN must be forwarded to the Load Balancer, so that they can be forwarded to the Internet. This is done by configuring other Routers to use the VPN 800/2 Firewall Router as the Default Route or Default Gateway, as illustrated by the example below.

Static Routing - Example

Segment 1

 

 

(192.168.2.xx)

(192.168.2.80)

(192.168.1.100)

 

Router A

Segment 0

(192.168.1.xx)

(192.168.1.1)

Router B

(192.168.2.90)

(192.168.3.70)

Segment 2

(192.168.3.xx)

Figure 9-2: Routing Example

Page 69

Page 74
Image 74
HotBrick VPN 800/2 manual Configuring Other Routers on your LAN, Static Routing Example, Settings Routing