Hotpoint HUE 62 Care and Cleaning, Cleaning the glass doors DROP DOWN DOORS, Side Opening Doors

Care and Cleaning

Cleaning the glass doors

DROP DOWN DOORS

Open the door fully and carefully slide the first inner glass towards you, taking care not to allow the glass to fall.

If necessary, the glass can be pushed delicately from the back side.

Repeat the same procedure with the next glass.

Now the external glass panel can be washed.

WARNING! As soon as the inner and middle glass panels are removed , the door slams shut.

SIDE OPENING DOORS

Cleaning the door glass is the same as the drop down doors.

Open the lower door and lift out the inner door glass

Remove the two rubber anti-rattle bungs

Remove the centre glass taking care to support the weight of the glass when removing and fitting

The glass panels may now be washed at the sink. Stubborn stains can be removed by using a fine steel wool soap pad.

Replace in the reverse order.

Ensure anti-rattle bungs are fitted before fitting inner
	GB
door glass.
BE CAREFUL NOT TO DAMAGE THE GLASS
PANELS BY PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly
ie reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to
damage the inner surface which is coated with a heat
reflective layer. After cleaning, rinse and dry with a
soft cloth. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door
Warning: Oven must not be operated with inner door
glass removed.

Anti- rattle bung

The door glass is equipped with anti-rattle bungs which prevents rattling of the glass when opening and shutting the oven main door. These can be removed for

washing.

WARNING : Be careful not to lose the bungs when cleaning

Door and Control Panel (Glass)

Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth.

Door and Control Panel Trims (Stainless Steel) Regularly wipe with a clean, damp cloth and polish with a clean, dry cloth.

Replacement of the Oven Light

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

Unscrew the glass cover, using a suitable cloth to protect the fingers and remove carefully. Unscrew the existing light bulb, and remove. Screw the new bulb into position and replace the glass cover, with metal washer, until positioned securely.

23