,... ,.,~
Ovenshelvesmay be cleanedwith a mildabrasivecleanserfollowing manufacturer’sdirections.After cleaning,rinse theshelveswith clean waterand dry witha clean cloth.
oven Li@t Bulb
The light bulb is located in the upper left corner of the oven. Beforereplacing the bulb, disconnect electric power to the range at the main fuse or circuit breaker panel or unplug the range from the electric outlet. Let the bulb cool completely before removingit. Do not touch a hot bulb with a damp cloth as the bulb will break.
To remove: Hold hand under lamp buIb cover so it doesn’tfall when released. With fingers of same hand, firmly push down wire bail ul]tilit
ToIreplace cover: Place cover into
groove of lamp receptacle. Lift wire bail up to center of cover until it snaps into place. When ii]place, tvire holds cover firmly. Be certain wire bail is not below depression in center of cover.
E?emovableOvenBO~~Om
YOUcan removethe ovenbottom to clean any excessivespillovers beforestartingthe
To remove the oven bottom: 1. Removethe ovenshelves.
2.Removethe two knurled hold- down screws at the rear of the oven. If they are too tight to removeby hand, use a coin or screwdriver.
3.To lift out the ovenbottom, place your fingers in the slots in the bottom and lift the rear of the oven bottom up and back until the oven bottom is clear of the lip at the front.
4.Then lift the bottom up and out. To replace the bottom, place it in the oven with the back raised about
6to 8 inches or until you can insert the front of the ovenbottom under the
Then push the back of the oven bottom down fully into place on the metal flanges and insert the hold-
down screMJs.
The ovendoor is removableto makethe interiormore accessible during replacementof the lamp bulb.
Open the ovendoor fully and removethe two Phillips screwsthat hold the door to the hinges. Then close the door to the automatic stop position (at about 3 inches open), and lifi the door straight up and off the hinges. (Dueto the large amount of insulation and the construction of the door, it is heavy.)
I
Note: Care should be taken not to place hands between the spring hinge and the oven door frame as the hinge could snap back and pinch fingers.
To replace the door, make sure the hinges are in the “out” position. Position the slots in the bottom of the door squarely over the hinges. Then lower the door slowly and evenly over both hinges at the same time. If hinges snap back against the oven frame, p~ll them back out. When the door is in position, open it fully and insert tl~etwo Phillips
screws.
