Using the Switch Console
Using the Switch Console
Starting and Ending a Console Session
Starting and Ending a Console SessionYou can access the switch console using either:
■a direct serial cable connection to the switch’s console port, as described in the installation guide that came with the switch
■through a Telnet session from a remote terminal device or from the switch’s web browser interface (the web browser interface provides for a Telnet connection from some of its screens)
N o t e | This section assumes that either a terminal device is already configured and |
| connected to your Switch 212M or 224M (as described in chapter 1, “Installa- |
| tion” of the HP Switch 212M and 224M Installation Guide) or that you have |
| already configured an IP address on the switch so you can start a Telnet |
| session with the switch. |
|
|
How To Start a Console Session:
1.Start your PC terminal emulator, or terminal, or Telnet to the switch from a remote terminal device or from the web browser interface.
2.Do one of the following:
•If you are using Telnet, go to step 3.
•If you are using a PC terminal emulator or a terminal, press [Enter] twice.
3.The screen briefly displays a message indicating the baud rate at which the serial interface is operating, followed by the copyright screen. Do one of the following:
•If a password has been set, the Password prompt appears. Type the password and press [Enter] to display the Main Menu (figure
•If no password has been set, you will see this prompt:
Press any key to continue.Press any key to display the Main Menu (figure