Network setup
Chapter 4
2.Press 
until Network is highlighted, then press OK. The Network Menu appears.
3.Press 1, then press 1 again.
This selects the Network Settings menu and then prints a configuration page for your HP
4.In the Address box in your Web browser on your computer, type the IP address of the HP
The Embedded Web Server Home page appears, showing information for the HP
Note If you are using a proxy server in your browser, you might need to disable it to access the Embedded Web Server.
5.If you need to change the language displayed in the Embedded Web Server, do the following:
a.Click the Settings tab.
b.Click Select Language in the Settings navigation menu.
c.In the Select Language list, click the appropriate language.
d.Click Apply.
6.Click the Home tab to access device and network information, or click the Networking tab to access more network information or to modify network information.
7.Make any configuration changes.
For more information see Use the Embedded Web Server setup wizard.
8.Close the Embedded Web Server.
Use the Embedded Web Server setup wizard
The network setup wizard provided in the Embedded Web Server gives you an intuitive interface to your network connection parameters. For more information on how to open the Embedded Web Server, see Access the Embedded Web Server.
1.Click the Networking tab.
2.Click Wired (802.3) in the Connections navigation menu.
3.Click Start Wizard, and then follow all of the wizard instructions.
Network configuration page definitions
The configuration page shows the network settings for the HP
For information on how to print a network configuration page, see View and print network settings. For additional information on terms used here, see the Network Glossary in the onscreen HP Image Zone Help that came with your HP
40 | HP Photosmart 3200 |