3Connecting to a Windows NT Server 3.51 Windows NT Workstation Version 3.51
Windows NT
Workstation
Version 3.51
Requirements
•HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
•3COM Etherlink
•Microsoft Windows NT Workstation 3.51 and Service Pack Media.
•Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
|
|
| Vectra VL8 |
| Vectra VL7 |
| Vectra VE7/VE8 |
|
|
|
|
|
|
|
|
| |
I/O Base Address |
| 210h |
| 210h |
| 300 |
| |
|
|
|
|
|
|
|
| |
Interrupt Request |
| 10 |
| 10 |
| 10 |
| |
| Level |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
• | Boot PROM |
|
|
| Disabled | |||
• | Transceiver Type |
| Auto Select | |||||
• | Network Driver Optimization |
| Windows or OS/2 Client | |||||
• | Maximum Modem Speed |
| 9600 Bps | |||||
• Plug and Play Compatibility |
| Disabled | ||||||
• | Full Duplex |
|
|
| Disabled | |||
Procedure
1With the HP Vectra turned off, install the 3COM Etherlink III
2Connect network cable media to the 3COM 3C509B card.
3Insert a DOS bootable diskette and power on the machine.
4After booting, insert the 3COM Software
5Select “CONFIGURE NIC” and verify the resource settings listed above under the heading “Device Configuration.”
6If changes are required, save those changes and exit.
If you are using a Vectra VL8 or VL7, go directly to step 7.
