NOTE
HP 10/100 3Com
HP Support Services
The PC Cannot Be Started or Woken up from the NetworkCheck that the WOL connector cable is connected to the network interface card and to the PC’s system board.
•If the PC has been powered off (for example, due to an electrical power failure, or because the power cord has been removed), the Remote Power On (RPO) will not work. To enable the RPO, you must first power on the PC, allow Windows 95 or NT 4.0 to boot, then shut down the PC.
•Check that the WOL connector cable is connected to the network interface card and to the PC’s system board.
•Check that the
RPO is only supported under Windows 95 and Windows NT 4.0.
HP Support ServicesThe latest drivers and utilities are available on HP’s Web site at:
http://www.hp.com/go/vectrasupport
English 15