Configuring
802.1X Open VLAN Mode
Configuring 802.1X Open VLAN Mode. Use these commands to actually configure Open VLAN mode. For a listing of the steps needed to prepare the switch for using Open VLAN mode, refer to “Preparation” on page
Syntax: aaa
Configures an existing, static VLAN to be the Authorized-
Client VLAN.
[<
Configures an existing, static VLAN to be the Unauthorized
For example, suppose you want to configure 802.1X
■These two static VLANs already exist on the switch:
•Unauthorized, VID = 80
•Authorized, VID = 81
■Your RADIUS server has an IP address of 10.28.127.101. The server uses rad4all as a
■The switch's default VLAN is already configured with an IP address of 10.28.127.100 and a network mask of 255.255.255.0
ProCurve(config)# aaa authentication
Configures the switch for 802.1X authentication using an
ProCurve(config)# aaa
Configures ports A10 - A20 as 802.1 authenticator ports.
ProCurve(config)# radius host 10.28.127.101 key rad4all
Configures the switch to look for a RADIUS server with an IP address of 10.28.127.101 and an encryption key of rad4all.
ProCurve(config)# aaa
Configures ports A10 - A20 to use VLAN 80 as the
ProCurve(config)# aaa
Configures ports A10 - A20 to use VLAN 81 as the
ProCurve(config)# aaa
Activates 802.1X