HP 6108, 4100gl, 2650 (J4899A/B), 2600-PWR manual CLI Viewing and Configuring Authorized IP Managers

Using Authorized IP Managers

Defining Authorized Management Stations

2.Enter an Authorized Manager IP address here.

3.Use the default mask to allow access by one

management device, or edit the mask to allow access by a block of management devices. See “Building IP Masks” on page 11-9.

4.Use the Space bar to select Manager or Operator access.

5. Press [Enter], then [S] (for Save) to configure the IP Authorized Manager entry.

Applies only to access through Telnet, SNMPv1, and SNMPv2c. Refer to the Note on page 11-3.

Figure 11-2. Example of How To Add an Authorized Manager Entry (Continued)

Editing or Deleting an Authorized Manager Entry. Go to the IP Manag- ers List screen (figure 11-1), highlight the desired entry, and press [E] (for Edit) or [D] (for Delete).

CLI: Viewing and Configuring Authorized IP Managers

Authorized IP Managers Commands Used in This Section

Command	Page
show ip authorized-managers	below
ip authorized-managers	11-7
<ip-address>	11-8
<ip-mask-bits>	11-8
[access <operator manager>]

Listing the Switch’s Current Authorized IP Manager(s)

Use the show ip authorized-managerscommand to list IP stations authorized to access the switch. For example:

11-6