HP 4710S manual

2.If it is necessary to replace the display bezel or display hinges, remove the eight rubber screw covers (1) and the eight Phillips PM2.5×4.5 screws (2) that secure the display bezel to the display assembly. The rubber screw covers are available in the Rubber Kit, spare part number 535793-001.

3.Lift the top inside edge of the display bezel (1) to detach it from the display assembly.

4.Lift the left and right inside edges of the of display bezel (2) to carefully detach them from the display assembly.

5.Carefully lift the bottom inside edge of the display bezel (3) to detach it from the display assembly.

NOTE: Make note of the routing of the display cable and the wireless antenna cable.

6.Carefully remove the upper hinge cover clips from the lower hinge covers on the display assembly.

CAUTION: The lower hinge covers can be damaged if care is not taken when removing the upper hinge cover clips.

7.Remove the display bezel from the display assembly (4). The display bezel is available using spare part numbers 535770-001 (for use only with models without a webcam) and 535769-001 (for use only with models with a webcam).

Component replacement procedures 61