HP 500B VS695UT VS695UT#ABA, 500B VS695UT 505B, 500B VS695UT 515B manual Replacing a Hard Drive

Replacing a Hard Drive

1.Follow the steps in Removing a Hard Drive on page 28 to remove the hard drive.

2.Slide the replacement hard disk drive into the bay.

NOTE: If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive.

Figure 2-39Installing the hard drive

3.Align the screw holes on the side of the hard drive with the holes marked “HDD” on the bay. Figure 2-40Align the screw holes

CAUTION: Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires.

Drives 31