HP 500B VS695UT 515B, 500B VS695UT VS695UT#ABA, 500B VS695UT 505B manual

10.If present, remove any cables connected to the add-in card. Figure 2-19Removing cables from the card

11.Store the removed card in anti-static packaging.

12.If you are not installing a new expansion card, install an expansion slot cover to close the open slot.

CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation.

13.To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board.

Figure 2-20Installing an expansion card

NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot.

18 Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis