Diagnostics reports a failure.

Cause

Solution

Network controller interrupt is shared with an expansion board.

Under the Computer Setup Advanced menu, change the resource settings for the board. Check that they are different from those of the network controller.

The network controller is defective.

Disable the integrated network controller from the setup utility and install a new network interface card.

Network controller stops working without apparent cause.

Cause

Solution

 

 

The files containing the network drivers are corrupted.

Reinstall the network drivers.

The cable is not securely connected.

Ensure that the cable is securely attached to the network connector and that the other end of the cable is securely attached to the correct device.

The network is temporarily unavailable.

Contact the network administrator to find out the status of the network.

Cannot connect to network server when attempting Remote System Installation.

Cause

Solution

The network controller is not configured properly.

Verify that the computer is properly connected to the network, that a DHCP Server is present, and that the Remote System Installation Server contains drivers for the network controller.

Solving Memory Problems

If you encounter memory problems, some common causes and solutions are listed in the following table.

System will not boot or does not function properly after installing additional memory modules.

Cause

Solution

Memory module is not the correct type or speed grade for the system or the new memory module is not seated properly.

Replace module with the correct industry-standard device for the computer. Do not mix ECC and non-ECC memory modules.

The memory module is not correctly seated.

Open the casing and reseat the DIMM.

 

 

Solving Memory Problems

81

Page 88 Page 90
Page 89
Image 89
HP 500B VS695UT 515B, 500B VS695UT VS695UT#ABA, 500B VS695UT 505B manual Solving Memory Problems
Page 88 Page 90
Top Page Image Contents