HP 700 G1 manual Expansion cards

Expansion cards

The computer has two PCI Express x1 expansion slots, one PCI Express x16 expansion slot, and one PCI Express x16 expansion slot that is downshifted to a x4 slot.

NOTE: You can install a PCI Express x1, x8, or x16 expansion card in the PCI Express x16 slot.

For dual graphics card configurations, the first (primary) card must be installed in the PCI Express x16 slot that is NOT downshifted to a x4.

To remove, replace, or add an expansion card:

1.Prepare the computer for disassembly (Preparation for disassembly on page 20)

2.Remove the access panel (Access panel on page 21)

3.Release the slot cover retention latch that secures the slot covers by lifting the tab on the latch and rotating the latch to the open position.

4.Locate the correct vacant expansion socket on the system board and the corresponding expansion slot on the back of the computer chassis.

5.Before installing an expansion card, remove the expansion slot cover or the existing expansion card.

NOTE: Before removing an installed expansion card, disconnect any cables that may be attached to the expansion card.

a.If you are installing an expansion card in a vacant socket, you must slide one of the expansion slot covers up and out of the chassis or use a flatblade screwdriver to pry out one of the metal shields on the rear panel that covers the expansion slot. Be sure to remove the appropriate shield for the expansion card you are installing.

Expansion cards 27