HP 700 G1 manual Post numeric codes and text messages, Download to Disable to prevent PXE

Control panel message	Description	Recommended action
		2. In Computer Setup, set Advanced >
		Device Options > NIC PXE Option ROM
		Download to DISABLE to prevent PXE
		option ROM for the internal NIC from
		being downloaded during POST to free
		more memory for an expansion card's
		option ROM. Internal PXE option ROM is
		used for booting from the NIC to a PXE
		server.
162-System Options Not Set	Configuration incorrect.	Run Computer Setup and check the
	RTC (real-time clock) battery may need to	configuration in Advanced > Onboard Devices.
	be replaced.	Reset the date and time under Control Panel. If
		the problem persists, replace the RTC battery.
		See the Removal and Replacement section for
		instructions on installing a new battery, or
		contact an authorized dealer or reseller for RTC
		battery replacement.

163-Time & Date Not Set	Invalid time or date in configuration memory.
	RTC (real-time clock) battery may need to
	be replaced.

Reset the date and time under Control Panel (Computer Setup can also be used). If the problem persists, replace the RTC battery. See the Removal and Replacement section for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement.

163-Time & Date Not Set	CMOS jumper may not be properly installed.	Check for proper placement of the CMOS
		jumper if applicable.
164-MemorySize Error	Memory amount has changed since the last	Press the F1 key to save the memory changes.
	boot (memory added or removed).
164-MemorySize Error	Memory configuration incorrect.	1.	Run Computer Setup or Windows utilities.
		2.	Make sure the memory module(s) are
			installed properly.
		3.	If third-party memory has been added,
			test using HP-only memory.
		4.	Verify proper memory module type.
201-Memory Error	RAM failure.	1.	Ensure memory modules are correctly
			installed.
		2.	Verify proper memory module type.
		3.	Remove and replace the identified faulty
			memory module(s).
		4.	If the error persists after replacing
			memory modules, replace the system
			board.
213-Incompatible Memory Module in Memory	A memory module in memory socket identified	1.	Verify proper memory module type.
Socket(s) X, X, ...	in the error message is missing critical SPD	2.	Try another memory socket.
	information, or is incompatible with the
	chipset.	3.	Replace DIMM with a module conforming
			to the SPD standard.
214-DIMM Configuration Warning	Populated DIMM Configuration is not optimized.	Rearrange the DIMMs so that each channel has
		the same amount of memory.

POST numeric codes and text messages 99