●Conductive foam

●Conductive tabletop workstations with ground cord of one-megohm +/- 10% resistance

●Static-dissipative table or floor mats with hard tie to ground

●Field service kits

●Static awareness labels

●Wrist straps and footwear straps providing one-megohm +/- 10% resistance

●Material handling packages

●Conductive plastic bags

●Conductive plastic tubes

●Conductive tote boxes

●Opaque shielding bags

●Transparent metallized shielding bags

●Transparent shielding tubes

Operating guidelines

To prevent overheating and to help prolong the life of the computer:

●Keep the computer away from excessive moisture, direct sunlight, and extremes of heat and cold.

●Operate the computer on a sturdy, level surface. Leave a 10.2-cm (4-inch) clearance on all vented sides of the computer and above the monitor to permit the required airflow.

●Never restrict the airflow into the computer by blocking any vents or air intakes. Do not place the keyboard, with the keyboard feet down, directly against the front of the desktop unit as this also restricts airflow.

●Occasionally clean the air vents on all vented sides of the computer. Lint, dust, and other foreign matter can block the vents and limit the airflow. Be sure to unplug the computer before cleaning the air vents.

●Never operate the computer with the cover or side panel removed.

●Do not stack computers on top of each other or place computers so near each other that they are subject to each other’s re-circulated or preheated air.

●If the computer is to be operated within a separate enclosure, intake and exhaust ventilation must be provided on the enclosure, and the same operating guidelines listed above will still apply.

●Keep liquids away from the computer and keyboard.

38

Chapter 4 Routine care, SATA drive guidelines, and disassembly preparation